• Disclaimer: This Vendor's Forum is a paid-for commercial area. Unlike the rest of diyAudio, the Vendor has complete control of what may or may not be posted in this forum. If you wish to discuss technical matters outside the bounds of what is permitted by the Vendor, please use the non-commercial areas of diyAudio to do so.

Twin Audio Full Range Speaker Kits

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Folded horn cabinet for FE206En is large and very high freight cost.

Any plans to make a kit for Fostex FE206En with Folded Horn cabinet?

Would be very interested for a 2A3 SE amp...

/V
 

Attachments

  • 206 BLH-2.jpg
    206 BLH-2.jpg
    171.1 KB · Views: 444
There are a few key parameters in a horn design that affects how it sounds: compression chamber size, horn length, closed-end cross-sectional area and opened-end cross-sectional area.
I have roughly estimated the parameters:
horn length: ~2.7m, should be longer
Compression chamber vol: >13L, can be tuned to taste according to Fostex
Closed-end XO area: 140cm^2
opened-end XO area:1225cm^2

With these parameters, we can engineer the horn with minimal calculations.
 
There are a few key parameters in a horn design that affects how it sounds: compression chamber size, horn length, closed-end cross-sectional area and opened-end cross-sectional area.
I have roughly estimated the parameters:
horn length: ~2.7m, should be longer
Compression chamber vol: >13L, can be tuned to taste according to Fostex
Closed-end XO area: 140cm^2
opened-end XO area:1225cm^2

With these parameters, we can engineer the horn with minimal calculations.

This sounds very interesting...
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.