EL156 amplifier
built one monoblock so far -
EF86 pentode RC coupled to an EL156. Adjustable bias, meter, b+ and bias measurement points. Tube rectified. Using all Hammond iron here.
built one monoblock so far -
An externally hosted image should be here but it was not working when we last tested it.
EF86 pentode RC coupled to an EL156. Adjustable bias, meter, b+ and bias measurement points. Tube rectified. Using all Hammond iron here.
Hi Bas Horneman, felixx
Tube use for input and driver is 4P1L of Soviet Union. 4P1L is pentode, direct heater.
This is datasheet
http://www.russiantubes.com/prop.php?t=12&p=71
My speker is Sony 5050/II
http://audio-heritage.jp/SONY-ESPRIT/speaker/ss-5050_ii.html
Regards,
Lotomo
Tube use for input and driver is 4P1L of Soviet Union. 4P1L is pentode, direct heater.
This is datasheet
http://www.russiantubes.com/prop.php?t=12&p=71
My speker is Sony 5050/II
http://audio-heritage.jp/SONY-ESPRIT/speaker/ss-5050_ii.html
Regards,
Lotomo
Re: my DAC
You bet! ... more pictures? Tech details? ... got USB / FireWire I/O ? 16 or 24 bit?
alpswolf said:Any body interest DAC?
You bet! ... more pictures? Tech details? ... got USB / FireWire I/O ? 16 or 24 bit?
Pix Ongen phono project
Hi
Some pictures from my two box 6C45-ECC188 phono project;
These are the subchassis, which are enclosed by a alu cover.
Those red Wimas are just used under the evaluation stage. They has been replaced by Rusian PIO´s
Passive EQ (RIAA)
Phonoamp chassis
PSU chassis
Brgds
Pix
Sweden
Hi
Some pictures from my two box 6C45-ECC188 phono project;
These are the subchassis, which are enclosed by a alu cover.
Those red Wimas are just used under the evaluation stage. They has been replaced by Rusian PIO´s
Passive EQ (RIAA)
Phonoamp chassis
PSU chassis
Brgds
Pix
Sweden
Finished pair of monoblocks
Shuguang made EL156 pentode connected in Ultralinear. EF86 pentode as driver. Loop negative feedback too.
oops, need to remove the Hammond stickers!
a 'moody shot'
Shuguang made EL156 pentode connected in Ultralinear. EF86 pentode as driver. Loop negative feedback too.
oops, need to remove the Hammond stickers!
An externally hosted image should be here but it was not working when we last tested it.
a 'moody shot'
An externally hosted image should be here but it was not working when we last tested it.
Re: My PP with 6P3S
Some wainscoting for power (output ?) transforemer ?
danzup said:This is my amplifier home-made with tube.
Some wainscoting for power (output ?) transforemer ?
- Home
- Amplifiers
- Tubes / Valves
- Photo Gallery