• Disclaimer: This Vendor's Forum is a paid-for commercial area. Unlike the rest of diyAudio, the Vendor has complete control of what may or may not be posted in this forum. If you wish to discuss technical matters outside the bounds of what is permitted by the Vendor, please use the non-commercial areas of diyAudio to do so.

SPP- revisiting a backburner project

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Jump to Latest
L

LaneM

Member
Joined 2016
Hey guys, I recently decided to pull out a backburner project on a SPP build I started about 4 yes ago. I've gone through notes and pics I took, but have some questions on terminating everything.
I've started a mockup build and after a bunch of reading, and my brain hurting, I'm just looking for some basic 101 answers, please feel free to fill in the blanks
Power supply Edcor XPWR008-120
RED to T1-RED 01- 03
YELLOW to T1-YEL 01-02
RED/BLK to T1-RED-YEL 01
BLACK COMMON to TI GRN 02
BROWN to TI GRN 01

Choke Edcor CXC100 5H 200MA to L1 01-02

MOTOR RUN cap ???

Output transformer CXPP-MS-8K/23%
YELLOW WHITE-spkr out/common 8ohm
GRN, ORG- not used
Blue and brown- go where??
Wht/blue-screen and white/brown-screen go where??
Red B+ go where??

Based on my OPT C101 should be what values?
Anything else I'm overlooking?
Thanks
 
Last edited:
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Top Bottom