• Disclaimer: This Vendor's Forum is a paid-for commercial area. Unlike the rest of diyAudio, the Vendor has complete control of what may or may not be posted in this forum. If you wish to discuss technical matters outside the bounds of what is permitted by the Vendor, please use the non-commercial areas of diyAudio to do so.

TSE C6?

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Jump to Latest
Tubelab_com

Tubelab_com

Member
Joined 2005
tubelab.com
Either will work, just make sure it fits in the board. My early amps used a B+ in the 320 volt range and I built them with 100 uF 350 volt caps. The later amps used 360 to 375 volts which required a 450 volt cap. Some 100 uF 450 volt caps are too large to fit in the PC board. The tall skinny ones are OK. The lead spacing is the issue, but I am not at home now and I don't remember exactly what the correct spacing should be.
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Top Bottom