• These commercial threads are for private transactions. diyAudio.com provides these forums for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members, use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

FS:ultimate attenuator kit for audio,balanced/single-end

This is a great KIT for those DIYers who want to build high-end quality audio DIY projects. It based on the following highlights:

R-2R current switching technology
High precision SMD resistors
High performance Analog switches DG413DY
Ultra-high performance Op-Amp AD797AR
Ultra-pure voltage regulator on board
Ultra-low noise
Ultra-low distortion
Low output impedance


Micro-controller with remote handset
4 input sources selectable

Wide range attenuation -96dB~0dB in 1dB/step

With this KIT, you can build a HI-END preamplifier easily ^_^

Price :
$250 single-end stereo
$450 balanced stereo
paypal accepted
airmail registered included

More information about my KITs ^_^
http://www.diyaudio.com/forums/swap-meet/135458-new-project-r-2r-attenuator-remote-control-v2.html

http://www.diyaudio.com/forums/swap-meet/144038-new-remote-volume-controller-10-sets.html

http://www.diyaudio.com/forums/swap-meet/130302-share-remote-volume-control-kit.html

attachment.php


attachment.php


attachment.php


USER MANUAL is ready, drop me an email ^_^
bbp6604560 at hotmail.com
orthoaudio at hotmail.com

thanks
 

Attachments

  • VOL ULTIMATE.jpg
    VOL ULTIMATE.jpg
    112.1 KB · Views: 4,270
  • VOL UL.jpg
    VOL UL.jpg
    98.2 KB · Views: 4,265
  • VOL U.jpg
    VOL U.jpg
    114.4 KB · Views: 2,667
Is one of the inputs a bypass input(signal in will be uneffected by volume control) so It can be used as a home theater-bypass??


sorry CustomHT, I reserved no bypass input,because the volume control is excellent enough for any audio applications ^_^

the input voltage range up to 10Vrms when you set the attenuation to 0dB,the module still provides low distortion signal
and even it accept 20Vrms input signal when you set the attenuation to -20dB
I most applications,the module can be deemed to a straight line when you set the volume attenuation to 0 dB

maybe a pass through is the best, but maybe w/o a pass through is no the matter ^_^

thank you
 
test performance added

Test result added

fully THD+N VS AMPLITUDE test
750 ohm loaded @ each phase of balanced
A-weighting
1mV to 16Vrms sweep

the blue line is the Residual performance
the green line shows the performance of this KIT
attachment.php


the gragh shows that the THD+N of R-2R VCS KIT is -110dB@5Vrms,only 1uV residual noise!
 

Attachments

  • THD+N VS AMP @ 750 oHM loaded A-wei.jpg
    THD+N VS AMP @ 750 oHM loaded A-wei.jpg
    89.9 KB · Views: 3,521