• These commercial threads are for private transactions. diyAudio.com provides these forums for the convenience of our members, but makes no warranty nor assumes any responsibility. We do not vet any members, use of this facility is at your own risk. Customers can post any issues in those threads as long as it is done in a civil manner. All diyAudio rules about conduct apply and will be enforced.

FS:D/A AD1865N-K Non Over Sampling

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
I used schematic from AN DAC KIT 1.1 but I modified solid state high volt rectifier to tube EZ-80 rectifier and used walt jung super regulator + spectral dms-20 instead of original supply.

All parts applied on single PCB (receiver + DAC + IV + tube + all supply)

I sale only full assembled PCB + transformer.
I ask for 315 USD shipping included.

My board included cs8414cs, ad1865n-k, ecc82, ez80, all digital and analog power supply.

I have only 2 set of PCBs

Thanks
Rubydac
 
My picture of DAC

I used Nichicon FW for 5V digital and +/- 5V analog supply also filaments rectifier, 0.47uF/400V spargue orange drop for tube output.

For analog filter I/V used RLC circuit, 1% resistor + 12mH separated coil + silver mica 0.01uF

EZ-80 for rectifer with PI stage filter which used 1K and 2.2 K resistors and rubycon 47uF/400V for filter capacitor.

For cathode bypass I used 330 ohms parallel with 220uF/25V phillips axial leed.

This's my hobby.

Thanks

Rubydac
 

Attachments

  • img_0317.jpg
    img_0317.jpg
    56.4 KB · Views: 255
My schematic

This's a schematic of my DAC.

I learned from many thread of AD1865N-K from DiyAudio, now I worked on SMPS design department but I loved DIY and sometime I used a freetime for design about digital schematic such as DAC, Class-T, Wireless LAN.

Thanks for contact
Rubydac
 

Attachments

  • img001.jpg
    img001.jpg
    85 KB · Views: 242
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.