|22nd November 2015, 05:54 AM||#11|
Join Date: Dec 2010
Cross·Spectrum - Galaxy CM-140 Sound Level Meter
I have not gone through them, yet. I was going to see if they could calibrate the mic I already bought from PE, and I think I need an SPL meter as well.
I know you said cheap. But how accurate is cheap?
I have no clue how to calibrate an SPL meter... So I am useless...
You can look into sound level calibrators...
If you use REW, you can use any calibrated mic for frequency, then use the calibrator to make sure your mic is dead on as far as SPL... (yeah, they are expensive, at least 200 bucks)
I use HOLM, and don't worry about measured SPL right now. I just measure the frequency response of each driver to check relative levels with same volume setting at crossover point... So I can't help you with true SPL response...
Last edited by TMHutson; 22nd November 2015 at 06:10 AM.
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|how to make this esr meter work with 250uA Panel meter||dytln_02||Everything Else||2||27th January 2007 10:13 PM|
|Scosche SPL meter: Cheap find with potential, or cheap junk?||theAnonymous1||Everything Else||5||11th October 2006 03:40 AM|
|inductance meter from a cheap meter?||jarthel||Parts||3||22nd September 2006 05:37 AM|
|Cheap autoranging meter||Jean||Parts||1||21st July 2002 02:42 AM|
|New To Site?||Need Help?|