|Solid State Talk all about solid state amplification.|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
||Thread Tools||Search this Thread|
|30th June 2004, 06:17 AM||#1|
Join Date: May 2004
Location: S. California
How to Revive an Aging Amp
I have a Parasound HCA-220II power amp which is showing its age. The midrange and bass isn't dynamic and fast as it used to be. Also, there seem to be a lost of details. I am wondering what I can do to bring the life back to this amp. I am thinking of several options:
1) Replace the bulk caps to newer and bigger caps. Originally values are 25,000 uF. What value should I use?
2) Replace the retifier diodes to higher current type.
3) Replace all the power transistors to new ones. There are 2SC3263 and 2SA1294. A total of 24 pieces altogether Not sure if this helps.
Will these modification work and are thre anything else I can do to improve the sournd?
|30th June 2004, 04:08 PM||#2|
Join Date: Nov 2003
Location: Brighton UK
I suggest replacing all the electrolytics only.
Better quality types are available, you can increase values by
a notch, e.g. 25->33, 33->47, 47->63 etc, double the smaller
values if you are so inclined, in a power amplifier should be fine.
For the electrolytics in the signal chain there is some mileage in
increasing voltage ratings, and bypassing with polycarbonate
types (or more expensive and larger polypropylene).
Clean all input and output sockets.
Finally with a soldering iron, solder and solder pump, methodically
resolder every joint in the amplifier. If your iron is not big enough
leave the larger joints for the power supply lines etc.
Replacing semiconductors will not help IMO.
|1st July 2004, 07:22 PM||#3|
Most likely the big electrolytics are ok so I'd leave them like that.
Support changing all the other electrolytics, Panasonic FC is very good & cheap for this purpose.
To properly solder the power lines (soldering is better with time instead of using crimped stuff in power amps or speakers) use a 100W soldering iron or get a soldering gun for this stuff only. Check fuse holders for oxidized parts. Clean all connectors with a contact cleaner.
Also check the connections for the speaker cable for loose/oxidized issues.
Regarding output trannies, there's no such thing as transistor aging.
We should no more let numbers define audio quality than we would let chemical analysis be the arbiter of fine wines. Measurements can provide a measure of insight, but are no substitute for human judgment. Nelson Pass
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Aging of components?, restoring old DIY||Christian||Solid State||18||27th November 2009 07:58 PM|
|Driver Burn IN and Aging||davecandialex||Multi-Way||3||15th May 2009 07:13 AM|
|Aging solder joins of power transistors||reins||Solid State||33||1st February 2007 01:55 PM|
|NOS Capacitors and aging||Paul Ebert||Parts||7||14th June 2006 05:09 PM|
|New To Site?||Need Help?|