Luxman L-2 power supply

[georgesgiralt]

Hello,
I've a "new" (for me) Luxman L-2 power amp.
The label on the back says 220V.
The transformer is the P2348 and it's primary is wired like this :
Brown Neutral
Orange Live
Red unplugged.
According to the schematics, my transformer should have a blue and a black wires on the primary, and be for 120V.
My mains is at 240V so :
1: Do you think there is a typo on the schematics ?
2) Should I unsolder the orange wire and replace it by the red one for 240 V ?
3) How could I know if I have a 240 V winding between the brown and red wires ?
Many thanks in advance for your help and advice !
Best regards.
P.S. : I've not, yet, powered the "device" ;-)

 

[Osvaldo de Banfield]

The pdf is clear in that there are only 2 cables, for a single primary winding, so no option to error: Black and Blue.

 

[Ketje]

If brown and orange is for 220V then maybee, since the orange is an itermediate tap, the red one could be for 240V.
Mona

 

[mbz]

If brown and orange is for 220V then maybee, since the orange is an itermediate tap, the red one could be for 240V.
Mona

I'd agree, red probably for 240Vac. If you can wait till sunday/monday I can
check mine, it's a 240Vac unit, currently away from home.

 

[georgesgiralt]

Hello,
I could not wait ;-)
I remembered I had a Variac. I put exactly 220 V on the primary and measured the voltage at the red wire. Bingo. 240V !
So I've to unsolder the orange wire and replace it with the red one...
Thank you for your help !