Zout = 0.49Ohm
So I won't add an o/p resistor
Some of your fellows have asked me if it is still possible to buy them.
The thing is.... I make as many as needed. There is a Limit on available KSC3503 and KSA1381.
But i would say a limit of 500 channel or 250 stereo sets but if more is needed i will make more of them....
The thing is.... I make as many as needed. There is a Limit on available KSC3503 and KSA1381.
But i would say a limit of 500 channel or 250 stereo sets but if more is needed i will make more of them....
Mine arrived on Tuesday.
So pleased that all SMT work is done!!! My 70 year old eyes would not see the parts let alone sort and solder correctly!!
I don't quite follow your remarks about Q18 +Q19. Are these now included in the cost? If so please send me these parts for a stereo set. I will send you the postage cost.
I will be on holiday in France until 22 September and hope to start building shortly after that date.
Thank you a good product and also for your speed and efficiency Sonny.
So pleased that all SMT work is done!!! My 70 year old eyes would not see the parts let alone sort and solder correctly!!
I don't quite follow your remarks about Q18 +Q19. Are these now included in the cost? If so please send me these parts for a stereo set. I will send you the postage cost.
I will be on holiday in France until 22 September and hope to start building shortly after that date.
Thank you a good product and also for your speed and efficiency Sonny.
Excuse me for my lack of participation .... I have been rather busy, as i have been asked if i could design a preamp for hypex modules as hypex don't offer such a solution for there boards.
That's super and very honourable recognition from Hypex, good for them.
I can now tell my friends that I had opportunity to cooperate with Hypex designer.
OK, I'm very still in unrecognizable area but close, just bellow you somewhere.
Idefixes, the feed-back resistance's position are the worse you can imagine. You could improve a lot distortion by doing something like this:I understand andrew and apply what you suggest(see under). For your value proposal let LC answer...
Marc
Attachments
Last edited:
What is the min V in we are supposed to get for full power?to get more gain.
775mV rms to fulfill DIN requirements ?
1V to match most of the digital equipment ?
1.25V to match professional symmetrical equipment ?
- Home
- Amplifiers
- Solid State
- TSSA - The Simplest Symmetrical Amplifier