Thank you so much sir Mile for answering all my queries regarding this brilliant creation of yours. I love to follow this thread every now and then...
God bless and more power...
vinski80
I modified it and made a PCB layout.
If the value of the components of the schematic is different from simulation file, the simulation is the correct one.
Hi Bimo,
Is this a Sprint file? Would you share it? If not. could you attach a mirror of the silk please? I would be willing to build this.
Blessings, Terry
The way you have connected R9 = 200 Ohm is not a good idea (your solution for OFFSET adjustment is not very efficiency). Please think again.
Hi Terry,
attached is the mirror silk. I have cleaned dark mount holes a bit. design is in eagle and I know the export in pdf is a bit ugly. Pl let me know if this is what u needed.
reg
prasi
Last edited:
The way you have connected R9 = 200 Ohm is not a good idea (your solution for OFFSET adjustment is not very efficiency). Please think again.
Do you think it must connect to emitter of the LTP (paralel with R5 and R10)?
Shematic is same as http://www.diyaudio.com/forums/solid-state/164093-100w-ultimate-fidelity-amplifier-569.html#post4544670
I change the R and C position because R connection to the transistor have high impedance, and it might interference from output signal.
Yes, it's much better, primarily because of R9 cursor in the event of interruption (in time may compromise the wiper resistance) does not cause the emergence of the offset voltage in the output stage.