Hi to all,
I am an absolute beginner in this field and the task is very simple: I would like to copy the existing single-sided layout of an existing through hole board from the eighties. No SMD, no multilayer. Goal is to check if the traces layout could be squeezed into a tighter place. So nothing is designed from scratch. It is a bit like a program that can turn a bookpage into editable text. I have the schematics as well. As symbols are standardized I also wonder if it has become a feature that a (printed) schematic can be translated into a pcp layout, especially when it is a single sided pcb. Mac preferred, freeware or a time limited trial.
All the best,
Salar
I am an absolute beginner in this field and the task is very simple: I would like to copy the existing single-sided layout of an existing through hole board from the eighties. No SMD, no multilayer. Goal is to check if the traces layout could be squeezed into a tighter place. So nothing is designed from scratch. It is a bit like a program that can turn a bookpage into editable text. I have the schematics as well. As symbols are standardized I also wonder if it has become a feature that a (printed) schematic can be translated into a pcp layout, especially when it is a single sided pcb. Mac preferred, freeware or a time limited trial.
All the best,
Salar
Last edited:
No, I'm not aware of any.Is there any software out there
that can translate/read printed schematics?
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.