• Disclaimer: This Vendor's Forum is a paid-for commercial area. Unlike the rest of diyAudio, the Vendor has complete control of what may or may not be posted in this forum. If you wish to discuss technical matters outside the bounds of what is permitted by the Vendor, please use the non-commercial areas of diyAudio to do so.

Lowering the output impdance of the TSSA V1.6

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
If it is required get more grip of the speaker, the following can be done:

Make the Errata note with 470R between Q13 and Q14 and between Q12 and Q15
R7 and R8 changed to 2K
change R22to 500R.
Do a new trim.

Trim to 500mA idle. As this gives the best distortion.

Distortion into 4W 8R is now 0.068% into 1KHz instead of 0.137%

Zout is now 0.28Ohm instead of 0.35Ohm.

The peak idle current at start up rises to 1Amp shortly for a few seconds. After 5 min it has settled to 500mA.
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.