PCL82 SE Tube Amplifier Kit
Is anyone familiar with this kit?
I would like to purchase one and I am looking for recommendations.
Thanks in advance
I´m not familiar with that particular kit, but I´ve built a few SE amps with PCL/ECL82 and that little tube continues to impress me.
Sounds way better than it deserves!
I built last year a stereo power using ECL82 ( similar to PCL82 -
with different heater voltage ) ultra-linear / push-pull configuration
7 Watts / channel ( based on Mullard 407 project from 50's ).
It sounds great , amazing sound quality and tonal richness, and
very , very smooth sound
These little tubes are amazing , and more they are cheap
I recommend them !!!
I built a very inefficient parafeed headphone amp using 2 ECL82's. It sound very good sweet and smooth. Better than I expected because most of the advise was to use ECL86's which are supposedly better valves. The triode section benefits from been run hotter than suggested on the datasheets. I run mine at double the current by halving the load and cathode resistor values. This allowed me to use more plate to plate feedback.
Take a look here
Go under "Prodotti" and then "Kits"... :D
|All times are GMT. The time now is 09:30 PM.|
Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 17.65%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Copyright ©1999-2020 diyAudio