diyAudio (
-   Tubes / Valves (
-   -   PCL82 SE Tube Amplifier Kit (

savakovacevic 14th January 2006 04:12 PM

PCL82 SE Tube Amplifier Kit
2 Attachment(s)
Is anyone familiar with this kit?

I would like to purchase one and I am looking for recommendations.

Thanks in advance

Fuling 14th January 2006 08:44 PM

Im not familiar with that particular kit, but Ive built a few SE amps with PCL/ECL82 and that little tube continues to impress me.
Sounds way better than it deserves!

refference 28th January 2006 02:54 AM

I built last year a stereo power using ECL82 ( similar to PCL82 -
with different heater voltage ) ultra-linear / push-pull configuration
7 Watts / channel ( based on Mullard 407 project from 50's ).

It sounds great , amazing sound quality and tonal richness, and
very , very smooth sound

These little tubes are amazing , and more they are cheap

I recommend them !!!


Shoog 28th January 2006 08:51 AM

I built a very inefficient parafeed headphone amp using 2 ECL82's. It sound very good sweet and smooth. Better than I expected because most of the advise was to use ECL86's which are supposedly better valves. The triode section benefits from been run hotter than suggested on the datasheets. I run mine at double the current by halving the load and cathode resistor values. This allowed me to use more plate to plate feedback.


Giaime 28th January 2006 09:41 AM

Take a look here

Go under "Prodotti" and then "Kits"... :D

All times are GMT. The time now is 05:16 PM.

Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 17.65%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Copyright ©1999-2020 diyAudio