diyAudio

diyAudio (https://www.diyaudio.com/forums/index.php)
-   Elektor (https://www.diyaudio.com/forums/elektor/)
-   -   Mini Crescendo worth reviving? (https://www.diyaudio.com/forums/elektor/365245-mini-crescendo-worth-reviving.html)

oodi 29th December 2020 06:30 PM

Mini Crescendo worth reviving?
 
I am finally getting back into audio gear. Raising kids has life go off in different directions? Back in 1984 I built the Mini Crescendo from Elektor plans but my own board layout. I built it in Germany before my move to Canada. It was last powered on around 1998. The toroid on the build is a 220V type which wonít work too well on our 110V here.

Question, if I picked up a new Hammond Mfg transformer I am stuck choosing the 60V or 80V Center Tapped. I am leaning towards 2x30V. Considering itíll be over $100 and the filter caps also need replacing I am wondering if this venture is even worth it?

Adi

Mooly 29th December 2020 06:41 PM

If it doesn't work out then the 30-0-30 transformer could be used for something else such as an LM3886 based amp (edit... a bit marginal perhaps for an LM3886 but there are lots of other designs). I wouldn't go any higher voltage wise.

The reservoir caps might be old but that doesn't mean they are no good. I would use a DBT (dim bulb tester) for initial powering up and do a quick check that the DC offset is zero at the speaker terminals.

A 220v 50Hz transformer on 110 volts 60Hz should work without issue... give it whirl... a low powered Micro Mini Crescendo.


All times are GMT. The time now is 10:45 AM.


Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 17.65%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2021 DragonByte Technologies Ltd.
Copyright ©1999-2021 diyAudio

Wiki