PCM5102A DAC Decoder I2S connection

[02GF74]

I have purchased one of these board, PCM5102A DAC Decoder I2S, with the intention to connect it to a SAA7345 which support Philips I2S data format.

Can anyone tell me where I can find the meaning of the pins. The board is shown below.
FLT
DMP
SCL
BCK
DIN - Data In?
LCK
FMT
XMT

The SAA7345 device has following outputs:
MISC general purpose DAC output (3-state)
DATA serial data output (3-state)
WCLK word clock output (3-state)
SCLK serial bit clock output (3-state)

I assume the two can be connected together but that may not be the case, without knowing what the pins on the board are I can't really tell.

 

[rfbrw]

The meaning of the pins will be found in the PCM5102A datasheet.

 

[Mark Tillotson]

BCK is bit clock, LCK is LR clock, DIN is indeed data in. Normally I2S signals are termed MCLK, BCLK, LRCLK and DIN / DOUT, but only had room to print 3 chars. See the datasheet for anything specific to the PCM5102A, and bear in mind they shortened the pin names.