diyAudio (
-   AKSA (
-   -   Loudspeaker cable with NAKSA70 (

Sjef 4th February 2019 12:50 PM

Loudspeaker cable with NAKSA70
Hi Hugh,

I'm changing my setup at the moment and with that I have to aquire some new loudspeaker cable. I have my I on supra-ply 3.4S but I was wondering if this is a good choice to be used with my NAKSA70 because it is a high capacitance cable. Mine would be around 22nF load to the amp. Is the NAKSA70 stable into that load or should I get something else?

AKSA 4th February 2019 10:00 PM

It should be fine as this amp is highly stable into cap loads, Sjef.
BUT I would not spend a lot of money on speaker cable; I have in the past used thick 25A auto wire and it worked just fine.


Sjef 5th February 2019 11:27 AM

Thanks for your answer,

I'm not going to spend much on cables indeed. I have been using cable talk 3.1 biwire for 25 years and it was allways just fine. Now I need some longer lengths and the Supra cable is cheap enough to try. I will report back if I hear any difference whatsoever. I don't expect much if any at all.

All times are GMT. The time now is 12:35 PM.

Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 17.65%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Copyright ©1999-2020 diyAudio