diyAudio

diyAudio (https://www.diyaudio.com/forums/index.php)
-   Equipment & Tools (https://www.diyaudio.com/forums/equipment-and-tools/)
-   -   hp8903a repair needed (https://www.diyaudio.com/forums/equipment-and-tools/234624-hp8903a-repair.html)

joustman 22nd April 2013 08:09 AM

hp8903a repair needed
 
Hi,
I have an hp8903a audio analyzer that does not display the proper voltage reading on input signals. I'm wondering if anybody has any experience in this area?
I have the schematics and can start poking around. I do not have board extenders which would make this task a little easier. The meter is way off so i don't think its a simple adjustment. Using a fluke it seems the output at least is accurate,
Thanks for any advice in advance.

gootee 22nd April 2013 11:36 AM

If you don't have the full service manual, get it. Check at agilent.com. If it's not there try the "boat anchor manuals archive" (BAMA) site.

joustman 22nd April 2013 01:09 PM

i have the full service manual.

macboy 6th May 2013 02:26 PM

At the input are a series of attentuators and a series of gain stages, each of which may be switched in or out depending on the detected signal level. You can check the level at each stage to determine where the level goes wrong. The service manuals are great, they have procedures to troubleshoot just about every circuit, including the inputs. Follow the check procedures! They include the use of special codes which override normal operation, and they describe what you should expect to measure at various test points, have frequent references to the schematics, and even suggest where to look for a fault when some test point doesn't measure right.

macboy 7th May 2013 12:04 PM

You won't need the riser card. Many of the test points and adjustments are located at the top of the board for easy access. Internally all boards plug into the chassis sort of like how PCI cards plug into a motherboard. If there is a test point that is obscured, you can remove the board (input board), attach some wires to the test points, and replace the board. You can then power up and take the measurements from those leadwires.

joustman 7th May 2013 12:09 PM

ok I'll give it a try. hopefully tonight.
I'll let you know the results.
BTW my email is barrybeadman@gmail.com I live a little west of Ottawa in Almonte.
I build Tube Amps for one of my hobbies which is why i need this thing. I've been dying for an audio spectrum analyzer and its almost within my grasp. all i need to do is fix this and find an HPIB interface card/dongle.


All times are GMT. The time now is 02:12 AM.


Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2018 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 17.65%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2018 DragonByte Technologies Ltd.
Copyright ©1999-2018 diyAudio

Wiki