Hookup wire

[Buzzy]

Can a speaker cable like canare 4s11 be used as a wire for internal wiring of a DIY amplifier ? I see that on canare website it states that it can be used for DC power line.

I need your opinion on this .

Thankz.

 

[Buzzy]

Any comments ?

 

[nelsonvandal]

I can't see why it couldn't be used. Any cable could be used if the dimension's right. Some people believe in the magic of cables and some don't.

 

[nigelwright7557]

Can a speaker cable like canare 4s11 be used as a wire for internal wiring of a DIY amplifier ? I see that on canare website it states that it can be used for DC power line.

I need your opinion on this .

Thankz.

So long as you use a good quality cable you should be fine.

Some cheap cable can be quite resistive.

I did a project for a surveliance system using cameras on quite long runs of wire. I did some research into different cables and was surprised at how good some cable is and how bad others are for voltage drop.

 

[Gordy]

Can a speaker cable like canare 4s11 be used as a wire for internal wiring of a DIY amplifier ? I see that on canare website it states that it can be used for DC power line.

The simple answer is 'yes, it should be fine'.

 

[nigelwright7557]

Re: Re: Hookup wire

The simple answer is 'yes, it should be fine'.

So long as it can carry the maximum current in the amp.

 

[unclejed613]

yes it will work well. remember to keep yput P/S wires short and away from input/vas stages. no matter how big, they will generate the same magnetic fields.