Could somebody check this schematic for a Capacitance Multiplier PSU?
I drew it after reading the article on Capacitance Multipliers at ESP:
If I got it right, its the single-ended version of Rod Elliott's design in figure 3.
I want to see how it sounds on the amp I built in this thread.
Superficially, your result looks to be the same as (the positive half of) that taken from Rod Elliot's site, unless I have missed something here.
However, there is no need to have 2 separate connections between the + terminal of the bridge and the collectors of the 2 transistors, as you have shown. These 2 traces are simply in parallel with each other.
|All times are GMT. The time now is 06:12 PM.|
Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 17.65%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
Copyright ©1999-2020 diyAudio