Need a design for a rectifier bridge producing 300V DC using a 450V 1000 micF 1mf cap

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.

PRR

Member
Joined 2003
Paid Member
Fender thought 16+16uFd was enough.

I'm the guy who just put a 6x6 beam where a 2x6 might have been fine, so I don't reject over-kill, but 15X oversize is mighty big.

(When you pull out the plug, the B+ will fall so slow the amp will play for some seconds, probably cutting-out on heater-cooling before B+ loss.)
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.