LR8N3 Regulator -- Bypass the ADJ pin

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
I thought that there was something wrong with that chart -- so used a 680uF cap to cure the F3 problem. Here's the new chart:

An externally hosted image should be here but it was not working when we last tested it.


Here's the test setup which I used -- the switch is closed when the electrolytic is discharged to about 20V -- this makes it safe to connect to the HP3581.

An externally hosted image should be here but it was not working when we last tested it.
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.