|24th May 2011, 01:27 PM||#1|
Join Date: Nov 2007
Would you be willing to share any info about how to apply the EnABL2 process to the EL70 drivers? I just bought a pair, and have Ed's kit. Was planning on just using your photos and the general advice... but any particulars would be greatly appreciated (like... do you pre-coat the paper cones, how many coats of clear do you apply after the dots, how diluted, etc)?
Thanks in advance for any support.
|24th May 2011, 04:13 PM||#2|
With EL70 i do one coat of pretreat with mod-podge, care needs to be taken to get full coverage. Be careful not to get finger oil on cone...
Then you'll need to tap out the ring placement. I do the middle cone ring in stealth. 2 coats of 50% gloss (q on dustcap)
Dustcap gets 3 1/2 rings. One on the vertical face, one right on the transition, and one on the face.
I use A5 and #56 for the rings,
That info and the pictures should get you there.
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|beautifull EL70 build||Henkjan||Full Range||5||9th February 2011 04:34 PM|
|El70 in Pensil?||type||Planet 10 hifi||12||11th September 2010 07:41 PM|
|Introducing The new CSS EL70||CSS/XBL||CSS||41||19th April 2010 09:23 PM|
|Using existing Boxes for my EL70||bobhowell||Full Range||7||5th January 2010 08:11 AM|
|Floorstander with EL70||AlejandroR||Full Range||16||20th December 2009 04:22 PM|
|New To Site?||Need Help?|