Tenacious 6+. 6cm Full Range 3D Printed Driver

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Hello everyone

Been a little while but back with my first 3D printed design based around a new magnet motor and new magnet size. In this case, 20mm N35 countersunk magnets.

The long term motor to match the Bl values I need will come from a larger build, but these seem like a easily accessible and flexible choice. Here is the T&S values, along with 2 frequency response graphs. There are 2 depending on the material chosen for the 3D printed cone:

The design is a Patreon exclusive, but wanted to show you all the steps forward that have been taken. There are still things to improve as we scale up a bit more, but these are a big step forward and helps to show the capabilities of 3D printing as a whole.

Any questions at all, feel free to ask away. One step closer to a end product!

Paul :)

https://twitter.com/Polymate3D/status/1365803867372466176
https://twitter.com/Polymate3D/status/1365667601968414732

^ Twitter posts are quick videos of them in action
 

Attachments

  • Tenacious 62.jpg
    Tenacious 62.jpg
    38.3 KB · Views: 127
  • Tenacious 6+ Datasheet.jpg
    Tenacious 6+ Datasheet.jpg
    267.4 KB · Views: 121
  • Tenacious 6+ Impedance.jpg
    Tenacious 6+ Impedance.jpg
    282.5 KB · Views: 127
  • PXL_20210227_134351726.jpg
    PXL_20210227_134351726.jpg
    620.3 KB · Views: 130
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.