Moode Audio Player for Raspberry Pi

[TimCurtis]

Yes of course, math and physics guarantees there will be a limit to the true resolution of the device.

[TimCurtis]

Originally Posted by matthiasw

Thanks Tim,

I forgot to mention that I would like to go for an USB-DAC like the upcoming Revolution DAC from Allo and I would like to let Audirvana do all DSD converting or upsampling.

So the signal path through Moode should be as pure as possible.

Does this change some settings you mentioned?

Thanks again.

Matt

If u are using moOde just as a UPnP renderer and i assume controlling volume with Audirvana or some downstream volume control device then you would want to set MPD volume to "Disabled (0dB)".

[matthiasw]

Originally Posted by TimCurtis

If u are using moOde just as a UPnP renderer and i assume controlling volume with Audirvana or some downstream volume control device then you would want to set MPD volume to "Disabled (0dB)".

Yes, volume control with analog preamp downstream.

With a wired ethernet connection to the SIG the setting would be:

Wait for eth0 address: ON

Correct?

I have searched many forums and did not found many issues in working together of Audirvana and Moode as UPnP renderer.

What is your experience?

Thanks

Matt

[TimCurtis]

Yes. When it's ON moOde waits up to 9 seconds for an IP address to be assigned before continuing its start up sequence. Typically an IP address is already assigned before moOde startup begins and so no wait occurs.

[Jempie]

Hi,

i want to protect the settings page with an password, so that only i can only change the settings, but i cannot override the source.

does anyone knows why it's protected

Thanks

[matthiasw]

Hi Tim,

cdsgames reported on the Shanti thread that USBridge Sig. does support up to DSD512.

I assume he tested it with MoOde.

I want to send high rate native DSD (not DoP) via UPnP to the SIG/MoOde and then to USB-DAC.

Do exist MoOde settings so that DSD stays native and does not get converted into DoP or PCM?

Thanks

Matt

[TimCurtis]

Hi,

Below is from the MPD manual.
User’s Manual — Music Player Daemon 0.22 documentation

"Native DSD playback is used automatically if available. DoP is only used if enabled explicitly using the dop option, because there is no way for MPD to find out whether the DAC supports it. DSD to PCM conversion is the fallback if DSD cannot be used directly."

[mhouston]

Ive installed and upgraded to the latest Moode but wish to use it as an access point. All good but what IP should I enter now.

Thanks

[mhouston]

Found it.

[BackinBlack]

Originally Posted by mhouston

Found it.

You'll find a lot more info over at -Moode Forum

Glad to hear you got it working

Happy Listening
Ian