Okay, probably a dumb question...
In my ongoing Aleph5 project I am disliking the 0.047 uF (or 47 nF) capacitor. Its too big for the KK pcb (where it is numbered C1, I think its C7 on the original layout of mr Pass).
As you can see here the leads are almost touching the resistors.
I now have 47 nF 630 V MKP from Digikey (leads are 20 mm apart). Is it alright to replace them with 250 V MKPs (eg these Wima 's have leads 10 mm apart ). The holes on the PCB are 6 mm apart.
What's best to use here soundwise (and fitting)??
Thanx
Ronald
In my ongoing Aleph5 project I am disliking the 0.047 uF (or 47 nF) capacitor. Its too big for the KK pcb (where it is numbered C1, I think its C7 on the original layout of mr Pass).
As you can see here the leads are almost touching the resistors.
I now have 47 nF 630 V MKP from Digikey (leads are 20 mm apart). Is it alright to replace them with 250 V MKPs (eg these Wima 's have leads 10 mm apart ). The holes on the PCB are 6 mm apart.
What's best to use here soundwise (and fitting)??
Thanx
Ronald
Leeuwarden said:Remo has Chateauroux MKP 0.047 for 1,40 euro.
Kost een drol
You mean "Kost geen drol" ?
Leeuwarden said:Remo has Chateauroux MKP 0.047 for 1,40 euro.
Kost een drol
Yes, forgot to look there.
Dimensions are 10*16. Standing on a flat side it might fit..
Although its probably too good for this purpose. Unfortunaltely going over does cost more than a drol. I'll ask him to mail it.
edit. damn verzendkosten 10 euro...
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Amplifiers
- Pass Labs
- C7 cap on Aleph5