Help needed: XP-25 Phono Ground Connector

[Audio4Fun]

Hi,

I need to replace a broken ground connector on a Pass Labs XP-25 phono preamp, I have been looking for it or something similar at Mouser without luck.

Can someone tell me the part number that I should look for.

Thanks

 

[rayma]

I think Pass Labs would send you one, contact them.

 

[tiefbassuebertr]

Hi,

I need to replace a broken ground connector on a Pass Labs XP-25 phono preamp, I have been looking for it or something similar at Mouser without luck.

Can someone tell me the part number that I should look for.

Thanks

looks like this one:
https://docs.rs-online.com/d1c0/0900766b81681828.pdf
https://eu.mouser.com/ProductDetail/Mueller-Electric/BU-P3760-9?qs=EO%2B2iqeaG03IyJLbLhCC9Q==

 

[rayma]

But it must fit the mounting hole exactly. He should contact Pass Labs.
This is expensive equipment and should be repaired correctly.

 

[tiefbassuebertr]

I would not call the exchange of this part a repair work - it's only a replacement (at least for me).
Regardless of that, I would also say that it is best to contact Mr. Nelson Pass.

 

[Jazz Man]

It looks like a bog standard 4mm banana socket.

 

[rayma]

Nothing used by Pass Labs is bog standard, and of course it must fit properly regardless.

 

[Jazz Man]

It's a terminal for connecting a wire, all that matters is that it's insulated from the chassis.

 

[Zen Mod]

yup, that one from Mouser (post #3) looks as adequate

 

[Mikerodrig27]

The mouser one with shipping should be less than $15. Cheap enough to try. It look like it is the correct one anyways.

 

[Audio4Fun]

Hi,

I found this connector at Mouser, Deltron 552-0600 WHT (Mouser# 164-4206), that looks almost identical, tonight I will check if the chassis hole fits.

Thank you

 

[Markw4]

^^^
That one does look about right (compared to one I saw very closeup). Still, don't know why a phone call to Pass Labs shouldn't produce a free one.

 

[Audio4Fun]

Hi again,

Finally, I was able to remove the ground connector from the XP-25, the Deltron connector mentioned above has the same dimensions.

Thank you all