Balance adjustment now working
Hi,
thanks to Alex, the balance adjustment by remote is now working
0.5dB steps from 0 to -7.5dB for both channels. I asked Alex to adjust up the time, when showing the adjustments done, in the display.
It was too short, and I had a hard time, reading that fast . Or, is me getting old , LoL ?
He have adjusted it up, but I’m waiting for him to send the new firmware. He is in Japan this week, so maybe sometime next week ?
Hi,
thanks to Alex, the balance adjustment by remote is now working
0.5dB steps from 0 to -7.5dB for both channels. I asked Alex to adjust up the time, when showing the adjustments done, in the display.
It was too short, and I had a hard time, reading that fast . Or, is me getting old , LoL ?
He have adjusted it up, but I’m waiting for him to send the new firmware. He is in Japan this week, so maybe sometime next week ?
Attachments
Last edited:
PCB´s
hi.
as i have started with the project i made the buffer pcb´s and the regulator pcb´s in china with JLCPCB.
i can say they are very fast, cheap and very good.
i have ordered all the parts at mouser and will start my project very soon hopefully.
here are some pictures from the pcb´s from china. nothing to complain about...
regards
slavko
hi.
as i have started with the project i made the buffer pcb´s and the regulator pcb´s in china with JLCPCB.
i can say they are very fast, cheap and very good.
i have ordered all the parts at mouser and will start my project very soon hopefully.
here are some pictures from the pcb´s from china. nothing to complain about...
regards
slavko
Attachments
Hello,
The latest binary is version 2.93, still not on HCFR but already given by email to few members here.
I adds the balance and trigger control.
I will add it on HCFR to make it easily available.
I am using as well JLCPCB for a while, yes they are efficient and cheap, no more reason not to do proto on PCB.
The latest binary is version 2.93, still not on HCFR but already given by email to few members here.
I adds the balance and trigger control.
I will add it on HCFR to make it easily available.
I am using as well JLCPCB for a while, yes they are efficient and cheap, no more reason not to do proto on PCB.
- Home
- Amplifiers
- Pass Labs
- UGS-muse preamp GB