Hello from Dallas

[mattlang]

Hi all,

I'm looking to do a little DIY modding on a really nice Luxman integrated amp and this looks like the perfect site to start learning. I'm not an electrical engineer but a physicist so the circuit analysis stuff isn't my strong suit. At any rate, If there's anybody here in Dallas, particularly TI (Texas Instruments) who might provide some guidance I'd appreciate it. In the meantime I look forward to participating and learning here.

Cheers,
Matt

 

[Pano]

Welcome to the forum Matt.
Have a look around the Solid State Amp threads, then you might want to post your request over there.
The more specific you are about what you want to do, the more help you'll get.

Have fun!

 

[kenpeter]

Down the street from TI, I do final test on some of their audio EVMs.

 

[planet10]

Welcome to the forum Matt.

dave

 

[mattlang]

Down the street from TI, I do final test on some of their audio EVMs.

Hi,

Thanks for the response. I'm trying to troubleshoot what appears to be a bad output in the preamp section of an integrated amp. I'm guessing it may be cap related but I have no experience troubleshooting or replacing. I think I have the schematic. Is this something you have any experience with? Thanks and I look forward to talking with you.

Matt

 

[HifiGuy84]

Hey matt, how old is the amplifier? I recently had and amplifier with some age and found that the caps had dried out and needed replaced.

Just a thought...

Nice to see people from Dallas.