Ok, so I repaired this amp. CH2 was fried. Replaced o/p transistors and two Fets. Both channels now work great into a load. When I switch the dip switched to bridge mode, (yes I know how to bridge these amps with these switches), I get a very feint signal and the CH1 clip LED lights with only a very small volume setting. Waveform on scope looks pretty distorted.
Any ideas? I can post a schematic.
Any ideas? I can post a schematic.
When I switch the dip switched to bridge mode, (yes I know how to bridge these amps with these switches), I get a very feint signal and the CH1 clip LED lights with only a very small volume setting. Waveform on scope looks pretty distorted.
Do you connect speaker to Red output connectors?
Regards zeoN_Rider
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.