|Yesterday, 07:58 PM||#12|
Join Date: Apr 2014
Location: Mountains of WNC
Demolition complete, wings removed and shelf edge relieved in center to accommodate front mounting of PA-130. Note horizontal vent above shelf and slanted upper chamber beginning at vent. Next I will extend depth of rear chamber by three inches ( I haven't decided about extending the shelf), add foam core duct to vent then sand and paint exterior. I'll post again after completion.
I have a packaged blue tooth amp on order to power them that XRK linked on another thread. It will be a lot neater than my naked "lunch money amp".
Last edited by EddieT; Yesterday at 08:19 PM.
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Designing around non-traditional driver sizes?||wg_ski||PA Systems||6||21st May 2015 09:49 PM|
|Regulated vs. Traditional||roibm||Power Supplies||14||6th May 2015 11:02 PM|
|SWAP traditional Fi(TRON 7) for DIY kit||naca5||Swap Meet||0||1st December 2013 06:09 AM|
|Beveridge vs traditional ESL?||markusA||Planars & Exotics||15||30th April 2011 08:42 AM|
|Passive I/V vs. traditional I/V, FFT pics.||A 8||Digital Source||49||7th June 2004 01:01 PM|
|New To Site?||Need Help?|