I assume it is glued on to the base of the basket. I am concerned about using heat near the magnet, or loosening the glue on the spider.
I am considering taping over the basket vents then drilling a small hole between where I think the basket and top piece is, so I can feel around, then sawing it off. I just hope the pole piece isn't vented..
Pic: this is just an image I found
I am considering taping over the basket vents then drilling a small hole between where I think the basket and top piece is, so I can feel around, then sawing it off. I just hope the pole piece isn't vented..
Pic: this is just an image I found
Attachments
Initial Report....
The cup is glued at the bottom to the bucking magnet. This is a ring magnet smaller than, and glued to, the bottom piece of the motor. The cup also contacts the top piece but is not glued to it.
I think I'll try quickly heating the base of the next one and twisting it off..
The cup is glued at the bottom to the bucking magnet. This is a ring magnet smaller than, and glued to, the bottom piece of the motor. The cup also contacts the top piece but is not glued to it.
I think I'll try quickly heating the base of the next one and twisting it off..
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Loudspeakers
- Full Range
- Removing magnetic shield FE127E