Pair of CHR70.3's Just Ordered!

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
One more concern: the soldering of the wires to the speaker terminals. What's the best way to do that without melting the plastic pieces connected to the metal tab?

Skinny wire as mentioned by P10 will sink less heat away from the soldering site. Clean the tabs, use a good solder with flux core, a hot iron with a large enough tip (0.125" is OK) and be quick, but don't rush. ;)
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.