Dats V2

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Oh, yeah. :)

It does detailed analysis of resistors, caps and coils.

Also does full impedance plot of a driver in the cabinet (which you need for crossover simulation) as well as the finished speaker like you often see in Stereophile:

918ParaP5Ffig1.jpg


Which is a great troubleshooting tool. When you finish building a speaker, you compare your simulated crossover impedance to measured. This will often show bad parts or bad solder joints. If a speaker sounds odd, you can test the impedance to see if the two sides match.

Stuff like that.
 
Last edited:
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.