|4th November 2021, 10:05 PM||#1|
Join Date: Nov 2021
8600s voltage help
Hopefully someone can help. I recently built the 8600s with lundahl transformers. And it sounds fantastic. However, in my right channel the voltage starts out spot-on but then starts to vary. For example:
after 30 minutes.
TP4 109 one time then 29. Very strange
I quadruple checked the component placement and it lines up.
In addition, had an issue with one of the PCs 201 or 202 that the instructions indicated to put it one way and pages 22, the pcb chart, said another way - I put it the way on page 22 but maybe that isn't correct.
I checked the soldering but will check my solder on tube v1 pin 1, and PC202, and v4 tube pin 2?
Any advice would be appreciated.
|Thread||Thread Starter||Forum||Replies||Last Post|
|TU-8600S ---> new Lundahl LL2785||vkung||Elekit||1||2nd October 2021 12:44 PM|
|Just built TU-8600S could really use help troubleshooting||BigBand||Elekit||3||2nd April 2021 12:13 AM|
|Pre-Order TU-8600S||vkung||Elekit||44||3rd December 2020 05:07 PM|
|TU-8600S upgrade options||vkung||Elekit||0||15th June 2020 07:41 PM|
|NEW TU-8600S Lundahl LL2785B||vkung||Elekit||0||7th May 2020 04:01 PM|
|New To Site?||Need Help?|