Hello guys.I need some help about some jitter measurements from anyone who is good with statistics.
Say we have a clock with 11.000.000Hz mean center frequency,and on the 68% probability window we have +- 0,5Hz Standard dev.
how can we express this in picosecond RMS?
Thanks
SD
Say we have a clock with 11.000.000Hz mean center frequency,and on the 68% probability window we have +- 0,5Hz Standard dev.
how can we express this in picosecond RMS?
Thanks
SD
Any help with the math involved?
Are you kidding?
But being familiar with a lot of HP gear, but not the piece you are using, I'd just suggest you cuddle up with the manual, I'm sure it's all in there.
Regards, Allen
Thanks Allen
Lots of info and application notes from HP.
Unfortunately ,i am not kidding about the mathI want the most accurate,yet fast way to go from the frequency to the time domain,that is from the standard deviation in Hz to psec_rms ,and i am quite rusty on these stuff.
Thanks again
Regards
Stavros
Lots of info and application notes from HP.
Unfortunately ,i am not kidding about the mathI want the most accurate,yet fast way to go from the frequency to the time domain,that is from the standard deviation in Hz to psec_rms ,and i am quite rusty on these stuff.
Thanks again
Regards
Stavros
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.