CSR8645 HFP and caller ID

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Hi all,

I have been reading almost all https://www.diyaudio.com/forums/dig...luetooth-4-0-aac-apt-module-baseboard-32.html and after bricking and unbricking the device I am pretty good at playing around with that chipset.

I have a question related to the HFP profile as I am trying to build up my own hand free set and I wish to get the caller ID when sb is calling me. I have tried to configure caller ID and the other options in the configuration tool but I cannot get anything out of it. I have a V 3.2 board and it seems like the UART is disconnected and I dont know where to get the caller ID from. I've also tried to change the UART Pin 000e and 000f (RX-PIO14 and TX-PIO15) as mentioned on the official datasheet at page 30 but still nothing.

Am I doing something wrong?

Any tip will be highly appreciated.
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.