How to wire 1 SMPS400 + 2 UcD Amp

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
I have made some Y cables but they don't look great (photo). Is there a more elegant way to do this type of wiring ?
 

Attachments

  • photo.JPG
    photo.JPG
    660.5 KB · Views: 252
That should work fine. I ran each cable directly from PSU to one module, then 'bounced' onto the next module. You can do this by measuring enough cable to the first module, then stripping the middle of the cable and crimping a spade in the middle then one at the end.

Hope that makes sense.
 
That's funny, I used your amp as an example. I thought you had stuffed the ends of the cables into the Faston spades. I tried but of course I couldn't get both wires in.

This is my amp. Same enclosure I think. Will be changing the speaker cables in the near future. Since the pic was taken, I have added the HxR regulators which have proven to be a great add-on.
 

Attachments

  • IMG_3338-web.jpg
    IMG_3338-web.jpg
    453.5 KB · Views: 139
  • IMG_3339-web.jpg
    IMG_3339-web.jpg
    233.6 KB · Views: 128
  • IMG_3337-web.jpg
    IMG_3337-web.jpg
    315.8 KB · Views: 117
Last edited:
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.