IRS2092 own design

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Hi.
Can anybody tell me whether it will work?
 

Attachments

  • sch.png
    sch.png
    63.2 KB · Views: 967
  • widok pcb.png
    widok pcb.png
    60.2 KB · Views: 923
Last edited:
Done, amp was playing, but when I had disconnected speaker, everything on PCB was hot and in a moment IRS and fet-s burned.
Unfortunately there wasn't C8A and heatsink, I have connected additional parallel resistors to R117A, R118A, R17A, because amp was clipping, when power supply was circa 2x35V, is possible that leads of that resistors was to long?
An externally hosted image should be here but it was not working when we last tested it.

(img from IRAUDAMP7D: 500Wx1@ 8? / 250Wx2@ 4?, ±45 ~ 60V | DigiKey )
 
Last edited:
You could try a resistor.
I have never used one so don't know what value it would need.

I have seen a similar problem with SMPS where they need a resistor across the output to keep them stable.
That's what I've heard too... This kind of equipment appears to require a certain load to assure stability. can't confirm it, because I have no experience with digital amps.
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.