Thank you.
I changed diode and started checking voltages on 10 pin connector near +- inputs and got to pin 4 , then blew changed diode again and small pop sound emitted from test speaker . when pin 4 probed for voltage.
1. 5v
2. -14.9v
3. 13.7v
Low power input selected and gain set lowest position
I changed diode and started checking voltages on 10 pin connector near +- inputs and got to pin 4 , then blew changed diode again and small pop sound emitted from test speaker . when pin 4 probed for voltage.
1. 5v
2. -14.9v
3. 13.7v
Low power input selected and gain set lowest position
Zener diode. I've seen both 5.6 and 6.8v there. Either will work.
Can you give me a part number for it. It has 3 soldier points, which confuses me as all the zener I have seen is 2 points be it smd or wire in and out. It says 5.6 3j. Can I use a old style glass zener? Every pic I see is not like this one.
Thanks
- Home
- General Interest
- Car Audio
- JL 500/1 component identification