http://i68.tinypic.com/2cpz6rr.jpg
This are the signal of the high side switching signal that feeds the gate of the output mosfets.
Should It Be a Better looking sqarewave?
This are the signal of the high side switching signal that feeds the gate of the output mosfets.
Should It Be a Better looking sqarewave?
So, the problem is: the amplifier becomes hot After few minutes without load... So i open It and i changed all output MOSFET but they continue to heat up without a load. I check and It drain 3.2 amp without load...
I check with my oscilloscope on the gate and i posted the image before... I dont know what Is the problem
Do you understand now?
I check with my oscilloscope on the gate and i posted the image before... I dont know what Is the problem
Do you understand now?
How hot is hot?
What is the part number on the class D driver board?
How did you get them when a mains powered scope? You can't ground to the transistor.
The waveforms are not that unusual. Below are the drive signals from an older but similar amp.
What is the part number on the class D driver board?
How did you get them when a mains powered scope? You can't ground to the transistor.
The waveforms are not that unusual. Below are the drive signals from an older but similar amp.
Attachments
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- General Interest
- Car Audio
- Rockford Fosgate punch p1000-1BD