get below wave forms
An externally hosted image should be here but it was not working when we last tested it.
An externally hosted image should be here but it was not working when we last tested it.
Installing the jumper would have done the same but wouldn't have risked you hitting the high-side drain with the scope's ground clip. Measure the resistance between the high-side source and the low-side drain and you'll see what I mean.
As long as you got it done, that's what's important.
As long as you got it done, that's what's important.
Hi all,
working on this amplifier again, fitted new psu fets and outputs
psu: irf3205 with 47 gate resistors
outputs: irf3415 - 78 ohm gate resistor per bank of 3 fets (originals were irf1310n)
Amp turns on but draws alot of current, doesn't not go into protect. Sin wave/audio is distorted.
is the gate resistor ok for the 3415?
working on this amplifier again, fitted new psu fets and outputs
psu: irf3205 with 47 gate resistors
outputs: irf3415 - 78 ohm gate resistor per bank of 3 fets (originals were irf1310n)
Amp turns on but draws alot of current, doesn't not go into protect. Sin wave/audio is distorted.
is the gate resistor ok for the 3415?
- Home
- General Interest
- Car Audio
- Fire Audio 2200D