I'm sure it will work great.
Its almost 3 times better than regular MT.
I'm using 2mm but there is 1.5 and 1mm also.
Well its back together.
I dried the cardboard and re-used it.
It fits almost perfectly flush with nothing on the big mosfets and the nylon shims from the factory work perfect on the smaller to220's but that thin cardboard must be needed to absorb vibrations and act as a gasket.
Its working great again I dont smell anything getting hot.
I put some white glue on the nuts.
I didn't crank them down this time, just snugged them to like 3 or 4 ft/lbs if that.
I think I went way too tight last time.
I dried the cardboard and re-used it.
It fits almost perfectly flush with nothing on the big mosfets and the nylon shims from the factory work perfect on the smaller to220's but that thin cardboard must be needed to absorb vibrations and act as a gasket.
Its working great again I dont smell anything getting hot.
I put some white glue on the nuts.
I didn't crank them down this time, just snugged them to like 3 or 4 ft/lbs if that.
I think I went way too tight last time.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.