Post your Analogue Source pics here

I like that too ... :)
Little more ...
 

Attachments

  • DSC08485.JPG
    DSC08485.JPG
    588.7 KB · Views: 1,985
  • DSC08492.JPG
    DSC08492.JPG
    328 KB · Views: 462
  • DSC08491.JPG
    DSC08491.JPG
    329.8 KB · Views: 518
  • DSC08490.JPG
    DSC08490.JPG
    324.7 KB · Views: 1,780
  • DSC08489.JPG
    DSC08489.JPG
    311 KB · Views: 1,770
  • DSC08488.JPG
    DSC08488.JPG
    315.1 KB · Views: 1,839
  • DSC08486.JPG
    DSC08486.JPG
    602.9 KB · Views: 1,907
  • Like
Reactions: 1 user
Well, finally I have finished my DIY project vacuum tube phono stage, here is some pics, and my set
 

Attachments

  • _small-PASH7607.jpg
    _small-PASH7607.jpg
    465.2 KB · Views: 481
  • _small1-PASH7544.jpg
    _small1-PASH7544.jpg
    275 KB · Views: 423
  • _small1-PASH7542.jpg
    _small1-PASH7542.jpg
    276.2 KB · Views: 460
  • _small1-PASH7514.jpg
    _small1-PASH7514.jpg
    262.3 KB · Views: 548
Beautiful Cold Beer.

My one metre of Oak worktop.
The bottom layer is fabricated from the offcuts of the top two layers.
I skimmed the edges with my router end-mill stylee by clamping a couple of strips of wood either side to use as a refence edge, worked a treat but I had to enlarge the base of my router to span the gap.
Tung oil finish.
 

Attachments

  • P1010373small.jpg
    P1010373small.jpg
    292.4 KB · Views: 1,504
  • P1010352small.jpg
    P1010352small.jpg
    295 KB · Views: 801
  • P1010337small.jpg
    P1010337small.jpg
    285.8 KB · Views: 754
  • P1010345small.jpg
    P1010345small.jpg
    326.4 KB · Views: 675
  • P1010346small.jpg
    P1010346small.jpg
    220.7 KB · Views: 712
  • Like
Reactions: 1 user
Updated ... modified the plinth size, the motor pod housing and the pulley changed to solid copper ( instead of aluminium )

Arm modified to micrometer VTA adjustment.

You cant see them in the picture but changed the feet from maglev to points resting on sorbothane pads.


IMG_1225.jpg
 
Last edited:
  • Like
Reactions: 1 user