|Analogue Source Turntables, Tonearms, Cartridges, Phono Stages, Tuners, Tape Recorders, etc.|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
||Thread Tools||Search this Thread|
|13th February 2011, 09:43 PM||#1|
Join Date: Jun 2009
Linn Axis PSU overhaul
I have a working but tired Axis PSU (011 Rev3).
I'm about to replace:
2x 47microF 250v
2x 220mF 16v
2x 33mF 350v
6 x22mF 50v
I intend using larger voltage versions.
The parts aren't temperature labelled; do you think it's worth having higher temp rated?
Is there an advantage replacing any of the following:
* R1, 47ohms +/- 5% [Someone mentioned putting in 2 varistors(?) but that sounds like changing the board layout, which is above my confidence level]
* Bridge rectifier.
* Two physically large resistors printed "273-0, 15k, 5%" ?
I don't know the wattage ratings for any of these.
Have I missed anything? I'm not an electronics whiz, but I'm good with a soldering iron. I know the board is dangerous and easily damaged.
|14th February 2011, 06:21 PM||#2|
It would help to see a circuit tbh
Always worth getting 105C rated caps if possible if it's hot running. Even if actual temperatures are below this the higher rated parts last far longer.
Make sure any replacements fit physically as there is nothing worse than seeing parts with bent leads trying to make them fit.
Installing and using LTspice IV. From beginner to advanced.
Help for Ruth & Dave
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Linn Axis Schematic||beamish||Analogue Source||12||20th February 2016 08:06 PM|
|Linn Axis psu almost fixed (i think!)||martiny||Analogue Source||0||4th March 2009 03:14 PM|
|R2 and R3 values on Linn Axis PSU||martiny||Analogue Source||3||4th March 2009 10:46 AM|
|Linn Axis PSU smoking||martiny||Analogue Source||0||1st March 2009 12:06 AM|
|My Linn Axis is Sick. Please help fix||bubbamc119||Analogue Source||53||26th January 2008 12:08 AM|
|New To Site?||Need Help?|