HELP ZETA-ARM bearing
Same of you have change the bearing of e zeta-arm??
Its movement is perfect ti up-down but the movement lateral isn’t easy, sweet and I think necessary to change the bearing
Here are 3 bearing in the up, and the same number in support point underneath, and this is very difficult ( o impossible ??) to open this. The up cylinder-screw where there is the 3 bearing is easy to open and change, bat the under, that think of same typos, I don’t know how use??
Now I have buy ceramic bearing for substitute ( 1/10” ) and I hope to make and obrtain a good work.
Help same of you have already do it??
Thank and best regards.
G.pietro
Italy-Treviso
Same of you have change the bearing of e zeta-arm??
Its movement is perfect ti up-down but the movement lateral isn’t easy, sweet and I think necessary to change the bearing
Here are 3 bearing in the up, and the same number in support point underneath, and this is very difficult ( o impossible ??) to open this. The up cylinder-screw where there is the 3 bearing is easy to open and change, bat the under, that think of same typos, I don’t know how use??
Now I have buy ceramic bearing for substitute ( 1/10” ) and I hope to make and obrtain a good work.
Help same of you have already do it??
Thank and best regards.
G.pietro
Italy-Treviso
Contact Mike Harris of the Moth Group in England. he should be able to assist you with your Zeta issues.
http://www.britishaudio.co.uk/aboutus.htm
http://www.britishaudio.co.uk/aboutus.htm
http://www.Audioorigamo.com (he is even present here in the forum) is doing repairs on the Zeta, as well as two tonearm specialist in Germany.
Years ago, I did such myself, but I have no longer time to repair stuff from others.
best regards, Hartmut
Years ago, I did such myself, but I have no longer time to repair stuff from others.
best regards, Hartmut
http://www.Audioorigamo.com (he is even present here in the forum) is doing repairs on the Zeta, as well as two tonearm specialist in Germany.
Years ago, I did such myself, but I have no longer time to repair stuff from others.
best regards, Hartmut
Hartmut,
The link appears to be bad.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Source & Line
- Analogue Source
- HELP ZETA-ARM bearing