Very near voltages on +/- rails, still not above 18V not to jeopardize the servo opamp. But maybe we can moderate them. How many mV drop between legs R1,R2 on each? mV/33R will answer mA. Lets see if we can drive the Leds to lower Vf total by upping those current limiting resistors. What value RxJ RyJ you installed by the way?
If talking about the pictured they are RyJ & RxJ. 5mV/1Ω=5mA. Right on design target. It seems that the Bargraph Leds are bit happy for Vf in your batch. Nearing 18V output. R1 & R2 33R limit J1 & J2 IDSS to 5mA and feeds it to the Leds. Still below max spec. Better if you make make all four of them 68R to lessen ma and Vf for the output voltage to back off a little. The R1 R2 locations can be seen in post#2 first picture for the dual mono PSU sections and polarities.It is 1R each, with drop of 5mv across both
- Home
- Source & Line
- Analog Line Level
- Salas DCG3 preamp (line & headphone)