I have the circuit below but would like to just use single gang pot and split the mono after it. Any help is appreciated.
http://i984.photobucket.com/albums/ae321/Graygem/HTLL.jpg
http://i984.photobucket.com/albums/ae321/Graygem/HTLL.jpg
My mistake in drawing. The wipers are not the grounded pins.
Here's the corrected one. Thanks.
http://i984.photobucket.com/albums/ae321/Graygem/HTLL2.jpg
Here's the corrected one. Thanks.
http://i984.photobucket.com/albums/ae321/Graygem/HTLL2.jpg
Last edited:
Would this do the job? The output is going directly into a NJM2073 amp. The input is coming from some kind of preamp. I cut down the r9 resistor to 470 because of the paralleled r9/r10. I don't know if I would have to do anything to the caps and res after the pot. Again, any and all help is appreciated.
Thanks.
Thanks.
Attachments
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Source & Line
- Analog Line Level
- Mono to Dual Channel convert