Go Back   Home > Forums > > >
Home Forums Rules Articles diyAudio Store Blogs Gallery Wiki Register Donations FAQ Calendar Search Today's Posts Mark Forums Read

AKSA Builders of market proven kits and modules at sound quality to rival the best in high end

Thread Tools Search this Thread
Old 23rd November 2015, 02:36 AM   #1
djg440 is offline djg440
diyAudio Member
Join Date: Jun 2011
Default AKSA 100 N+

Hi, I was hoping that I can get help with this problem with one board for my 100 N +. My trouble shooting knowledge is limited but capable of assembling boards and amps and pre amps from kits DIY. I replaced all the caps on both boards. First board powered up no problem voltages good , DC offset good,bias 52 mV seems good.
Second board started with fuses out I noticed Driver T5 and T6 copper heat sink getting very warm. Checked all solder joints connections and cap orientation . check voltage across R26 and R27 , 7 volts and 6.8 volts seems correct.Check voltage between R7 and R8 from right side closest to C5 to earth ground and got 26V seems good. Measure mA Bias,,,,,,, Problem,,,, With probes connected ,,, power up amp mV starts reading at single digits and slowly consistently mV increases to 65 mV at which time I shut down amp. I turned P1 Bias pot all the way counter-clockwise for lower bias,,,,, still same reaction bias mV starts out in the single digits and continues to increase to past 55mV and I shut down the amp. Does any one have a clue as to what has happened. I have put together multiple types of boards with no problem, I do not think I connected anything wrong? Thanks
  Reply With Quote
Old 23rd November 2015, 02:58 AM   #2
AKSA is offline AKSA  Australia
diyAudio Member
Join Date: Sep 2001
Location: Melbourne, Australia

Please email me from my website; I will need a close, detail picture of BOTH sides of the pcb, and you will need to tell me which of the two drivers is hot; the C4793 or the A1837.

Most of these problems are caused by removal and replace; this process can damage the pcb, and it's possible you might have damaged one of the caps or resistors.

It's fixable, but this is not the best medium to interchange the repair process - email is better,


Aspen Amplifiers P/L (Australia)
  Reply With Quote


AKSA 100 N+Hide this!Advertise here!
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
AKSA 100 PingPing AKSA 26 10th April 2014 04:35 AM
AKSA 100 schematic? DigiSoft Solid State 40 28th March 2010 02:17 AM
Fs Aksa 100 bacworth Swap Meet 4 5th December 2005 11:33 AM

New To Site? Need Help?

All times are GMT. The time now is 04:11 AM.

Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 15.00%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
Copyright ©1999-2019 diyAudio